Question 1

How much does a heat pump cost in Yorkshire in 2026?

Accepted Answer

Air source heat pump installation in Yorkshire typically costs £10,000–£16,000 for a full system including the heat pump unit, pipework, hot water cylinder, and controls. After the £7,500 Boiler Upgrade Scheme (BUS) grant, your out-of-pocket cost is typically £2,500–£8,500. A typical 8–10kW unit suitable for a 3-4 bedroom Yorkshire home costs £11,000–£13,000 installed, so with the BUS grant, the net cost is around £3,500–£5,500. Ground source heat pumps cost £18,000–£35,000 installed (grant of £7,500 still applies). YEERS provides fixed-price quotes including VAT — there are no hidden extras on day of installation.

Question 2

Is my Yorkshire home suitable for a heat pump?

Accepted Answer

Most homes in Yorkshire are suitable for an air source heat pump, but the economics improve significantly with good insulation. Key factors: loft insulation (should be 200mm+), cavity wall insulation (if applicable), and double glazing all improve heat pump efficiency. Floor heating or large radiators work optimally with heat pumps' lower flow temperatures (45–55°C vs a boiler's 70–80°C). YEERS conducts a heat loss calculation on every property — we size the heat pump correctly and, where necessary, recommend insulation upgrades as part of the project. Yorkshire's climate is ideal: heat pumps perform efficiently even at -10°C, and Yorkshire rarely drops below -5°C. Coastal properties near Hull and Bridlington may need stainless steel casings to resist salt air.

Question 3

What is the Boiler Upgrade Scheme and how do I apply?

Accepted Answer

The Boiler Upgrade Scheme (BUS) provides a £7,500 grant towards air source heat pump installation, or £7,500 towards ground source heat pump installation. There is no income limit — any homeowner can apply. Requirements: your home must have a current valid EPC (within 10 years) that does not recommend loft or cavity wall insulation (these must be installed first); the heat pump must be installed by an MCS-certified installer; you must be the property owner. YEERS handles the entire BUS application — we check your EPC, identify any insulation requirements, submit the voucher application on your behalf, and claim the grant directly. You simply pay the discounted net amount. The grant is currently funded until 2028.

Question 4

How much can I save on heating bills with a heat pump in Hull or Yorkshire?

Accepted Answer

Savings depend on what fuel you are replacing, your home's insulation, and electricity tariffs. Replacing gas central heating: A heat pump with a COP (coefficient of performance) of 3.5 uses 1kWh of electricity to produce 3.5kWh of heat. At current prices (electricity 27.69p/kWh, gas 6.24p/kWh), running costs per unit of heat are: heat pump = 7.9p (27.69p ÷ 3.5), gas boiler = 7.3p (6.24p ÷ 0.85 efficiency). The gap narrows significantly if you pair the heat pump with solar panels, charging it with free daytime electricity. On a heat pump + solar combination, many Yorkshire homeowners pay £300–£600/year for heating (vs £900–£1,400 for gas). Replacing oil heating: Savings are more dramatic — oil at 7.5p/kWh for heat vs heat pump at 7.9p but with solar bringing the effective rate to near zero.

Question 5

What size heat pump do I need for my Yorkshire home?

Accepted Answer

Heat pump sizing is based on a 'heat loss calculation' — the rate at which your home loses heat on the coldest day of the year. For a typical Yorkshire property: 2-bedroom terraced house (65–80m²): 5–7kW; 3-bedroom semi-detached (85–110m²): 7–10kW; 4-bedroom detached (120–160m²): 10–14kW; larger/older properties with poor insulation: 14–16kW. Oversizing a heat pump reduces efficiency (it short-cycles rather than running continuously at a low power level, which is where heat pumps are most efficient). YEERS uses MCS-compliant heat loss calculation software (MIS 3005) to size every system correctly.

Question 6

Can a heat pump work with my existing radiators?

Accepted Answer

Yes, in most cases — but some radiators may need to be upgraded. Heat pumps work most efficiently at lower flow temperatures (45–55°C), whereas conventional gas boilers run at 70–80°C. This means your existing radiators need to be approximately 2–2.5 times larger to deliver the same heat output at the lower temperature. In practice, many Yorkshire homes have slightly oversized radiators already, or rooms only need a 20–30% increase in radiator size, which can often be achieved by adding a single panel to existing double radiators. YEERS conducts a room-by-room radiator survey as part of the design process. Underfloor heating is the ideal heat emitter for heat pumps, running comfortably at 35–40°C.

Question 7

Do heat pumps work in cold Yorkshire winters?

Accepted Answer

Yes. Modern air source heat pumps operate efficiently down to -20°C ambient air temperature. YEERS installs Mitsubishi Ecodan and Vaillant arotherm+ units, which maintain a COP (coefficient of performance) of 2.0–2.5 even at -10°C — still twice as efficient as a direct electric heater. Yorkshire's climate is relatively mild — temperatures rarely drop below -5°C even in severe winters. The average winter temperature in Hull is 3–6°C; in York, 2–5°C. At 0°C, a modern heat pump runs at a COP of approximately 2.8–3.2, meaning it is still significantly more efficient than any combustion-based heating system. Heat pumps in Yorkshire are genuinely suited to the local climate.

Question 8

Can I combine a heat pump with my existing solar panels?

Accepted Answer

Yes, and this is one of the most financially powerful home energy combinations available. Your solar panels generate free electricity during daylight hours; your heat pump can be programmed to run during those hours, using free energy to heat your home or charge the hot water cylinder. This is called 'solar diversion' and is supported by most modern heat pump control systems. For a typical Yorkshire home, running the heat pump on solar energy during summer can reduce annual heating costs by 40–60%. YEERS designs solar + heat pump + battery storage combinations that coordinate all three systems intelligently, minimising grid electricity use and maximising your savings.

Question 9

How long does a heat pump installation take?

Accepted Answer

A typical air source heat pump installation in Yorkshire takes 2–4 days. Day 1: Outdoor unit positioned and secured, pipework run through walls (typically requires a single 100mm hole), refrigerant connections made. Day 2: Indoor unit (cylinder, pump station, expansion vessel) installed, radiator adjustments made, controls wired. Day 3: System commissioned, refrigerant charged, pressure tested, controls programmed. Day 4 (if required): Additional radiator work, underfloor heating connection, testing. YEERS assigns a dedicated project manager who communicates progress daily. Your home will have heating throughout the installation as we only connect the final pipework on the last day.

Question 10

What maintenance does a heat pump require?

Accepted Answer

Heat pumps require minimal maintenance compared to gas boilers. Annual: an annual service by a qualified heat pump engineer (YEERS offers a £149/year service plan) including refrigerant pressure check, electrical connections check, filter cleaning, and performance verification. Monthly: visually inspect the outdoor unit to ensure it is clear of debris, leaves, and snow accumulation. No Gas Safe engineer is required as there is no gas or combustion. Warranty: Mitsubishi Ecodan comes with a 5-year parts warranty, extendable to 7 years with registration. Vaillant arotherm+ has a 7-year warranty. Heat pumps have fewer moving parts than a gas boiler, leading to lower long-term maintenance costs. Average lifespan is 20–25 years.

Question 11

Are heat pumps noisy?

Accepted Answer

Modern heat pumps are very quiet. The outdoor unit of a Mitsubishi Ecodan or Vaillant arotherm+ operates at approximately 40–50 dB at 1 metre — similar to a quiet conversation or a refrigerator humming. Planning regulations generally permit heat pump installation without full planning permission under Permitted Development rights, but the unit must meet a noise threshold of ≤42 dB(A) at 1 metre from a neighbour's window. Most domestic heat pumps comfortably meet this. In Hull, York, and East Yorkshire, YEERS will check local authority requirements and advise on optimal positioning (usually the rear or side of the property) to minimise any noise impact.

Question 12

Can I get a heat pump under ECO4 for free?

Accepted Answer

Yes, in some circumstances. Under the ECO4 scheme (running until March 2026), households with an EPC rating of D or below and income under £31,000 (or qualifying benefits) can receive a free air source heat pump as part of a wider energy efficiency package. The ECO4 requirement is that the package of measures must improve your EPC rating by at least one band, so a heat pump is often installed alongside insulation upgrades. Additionally, Hull City Council's LA Flex provisions extend ECO4 eligibility to fuel poverty cases in Bransholme, Orchard Park, and East Hull. YEERS can assess whether you qualify for an ECO4-funded heat pump at no cost to you.

System Type	Installed Cost	BUS Grant	Net Cost
Air Source (8kW) — typical 3-bed	£11,000–£13,000	£7,500	£3,500–£5,500
Air Source (10–12kW) — larger home	£13,000–£16,000	£7,500	£5,500–£8,500
Ground Source (8–12kW)	£20,000–£35,000	£7,500	£12,500–£27,500
ECO4-funded (eligible households)	Up to £10,000 package	100% funded	£0

Heat Pumps Yorkshire

Heat Pumps Yorkshire: The Complete 2026 Guide

Heat Pump Costs & Grant Funding Yorkshire 2026

300–400% Efficiency

£7,500 BUS Grant

Zero On-Site Emissions

MCS Certified

Our Heat Pump Products: Mitsubishi & Vaillant

Mitsubishi Ecodan

Vaillant arotherm+

Heat Pump + Solar: The Power Combination

Frequently Asked Questions

Free Heat Pump Survey

Related Services

Our Credentials

Heat Pump Installation by Location

Hull

York

Beverley

Driffield

Bridlington

Goole

Cottingham

Hornsea

Hessle

Scunthorpe

Grimsby

Market Weighton

Pocklington

Combine with Solar for Maximum Savings

What Our Customers Say

Start Your Project Today

Call Us

Email Us

Visit HQ